Opener Repair · Meridian, MS
Motor humming, remote dead, or the door reversing halfway down.
Chain, belt or screw drive, the failure list is short: gear, capacitor, board, limits, sensors, remote programming. We carry the parts for most of it, so a Meridian opener call usually ends with a working door rather than a quote for a new unit.
We find out what actually failed - gear, capacitor, board, sensor or limit switch - before quoting anything.
The most common repair on chain and belt units, and far cheaper than a new opener.
Knocked-out sensors cause most 'door reverses for no reason' calls. Realignment is quick.
If the unit is past repair we quote a new one, fit it, program the remotes and take the old one away.
Real ranges, not a teaser price. The exact number depends on the door, the parts and the access, and you get it before we start.
| Work | Typical range |
|---|---|
| Diagnostic visit | $65 - $95, credited against the repair |
| Drive gear kit | $140 - $260 |
| Circuit board or capacitor | $150 - $300 |
| Safety sensor repair or replacement | $90 - $180 |
| New opener supplied and fitted | $450 - $900 |
We would rather tell you 'tomorrow, eight to ten' than 'today, sometime' and leave you waiting in.
A door that holds at waist height by hand is a door that will not eat its opener. We do not leave until it does.
Some doors are finished. We will say it, quote the replacement, and not push you to decide on the spot.
We know which subdivisions around Meridian were built with light hardware and what usually goes on them first.
One call, a real arrival window, and a price before the work starts.
Whatever you can tell us helps us load the right parts before we set off.
Whole-system check: springs, cables, drums, bearings, rollers, hinges, track, opener, sensors.
Including the option of not doing the work, if that is genuinely the right answer.
We run the door with you there and show you it is balanced before we leave.
Worn rollers and dry hinges make the opener work harder and sound worse. Sometimes the noise is the door, not the motor at all.
Worn rollers and dry hinges make the opener work harder and sound worse. Sometimes the noise is the door, not the motor at all.
